R&S M3SR 4100 Series - Selecting the Data Rate for SECOM-H Transmission

Operating Manual 6175.4760.02 – 01 4.187
M3SR Series 4100 Selecting the Data Rate for SECOM-H Transmission
4.8.4.6 Selecting the Data Rate for SECOM-H Transmission
By means of softkey 'Datarate' the operator can change the data rate for SECOM-H trans-
mission.
Softkey Type Description
Listbox 1. Press softkey 'Datarate'.
2. Select desired data rate from listbox.
3. Press 'ENT' to confirm.
The new selection is now effective.
Possible values.
WF1: 75, 150, 300, 600 bps
WF2: 300, 600, 1200 bps
WF3: 1200 bps
WF5: 1200, 2400 bps
see also dependency Table 4.8