R&S M3SR 4100 Series - Selecting the Power Level

M3SR Series 4100 Selecting the Power Level
4.32 Operating Manual 6175.4760.02 – 01
4.3.5.16 Selecting the Power Level
Softkey Type Description
Listbox 1. Press 'Power' softkey.
2. Select desired power level from listbox.
3. Press ENT to confirm.
Possible output power levels for 150 W sys-
tems:
10 mW - 10 W - 20 W - 50 W - 100 W - 150 W
Possible output power levels for 500 W sys-
tems:
10 mW - 20 W - 50 W - 100 W - 250 W - 500 W
(when ordered with CE mark, limited to 250 W
for f < 4 MHz)
Possible output power levels for 1000 W sys-
tems:
10 mW - 50 W - 100 W - 250 W - 500 W -
1000 W (when ordered with CE mark, limited
to 250 W for f < 4 MHz)
By selecting a higher output power, the signal-
to-noise ratio at the receiver is increased,
which allows the communication coverage to
be extended.