M3SR Series 4100 Menu Radio MTC 2/7 (3002)
3.76 Operating Manual 6175.4760.02 – 01
Open an editor and select the attenuation applied on the
backplane audio connector LSB (audio line in signal).
Select the attenuation with the knob or with the numeric
keypad.
Default: 0.0 dB
-10.0 dB to 10.0 dB
Open an editor and select the attenuation applied on the
backplane audio connector LSB (audio line out signal).
Select the attenuation with the knob or with the numeric
keypad.
Default: 0.0 dB
-10.0 dB to 10.0 dB
Navigate to the subdomain VoIP. The first menu is the
VoIP 1/2 menu (see sect. 3.4.6 Menu VoIP 1/2 (3061)).
The radio supports VoIP. It can be used with devices com-
pliant to ED137B, as well as with standard SIP equipment.
Open an editor to change the radio gateway address.
Use the knob or the numeric keypad to edit each of the four
numbers of the address separately.
To select the next octet (xxx.) press the key
0.0.0.0 to 255.255.255.255
Press 'ENT' to confirm.
The gateway address 0.0.0.0 means that no gateway is
used. There are not all gateway addresses allowed.
See also the note below.
Default: 0.0.0.0
Open an editor to change the radio subnet address.
Use the knob or the numeric keypad to edit each of the four
numbers of the address separately.
To select the next octet (xxx.) press the key
0.0.0.0 to 255.255.255.255
Press 'ENT' to confirm.
There are not all subnet addresses allowed. See also
the note below.
Default: 255.255.255.0
Softkey Description Possible Values
To Next Page
Loading...
Need help?
General
