Operating Manual 6175.4760.02 – 01 4.87
M3SR Series 4100 ALE-3G Configuration Menus
Display of the Packet Aggregation Setting (ON/OFF).
The operator can see if packet aggegation is used or not.
This parameter can only be changed using the R&S Mission Planner.
Display of the xDL Port Setting
When DT1 is used as data source for xDL, the xDL-protocols are used like a modem with a
RS232 interface. The data will be internally packetized to 1500 byte packets and transferred
with xDL to the next call address or the linked partner station.
If IPoA is used as data source the radio has a Transparent IP interface based on ethernet or
PPP. See sect. 5.3 IP over Air (IPoA) for further information concerning this.
To Next Page
Loading...