EasyManuals Logo

R&S M3SR 4100 Series User Manual

R&S M3SR 4100 Series
706 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #552 background imageLoading...
Page #552 background image
M3SR Series 4100 Roles of Radios Supporting GPS Reporting
5.6 Operating Manual 6175.4760.02 01
5.2.1.1 Roles of Radios Supporting GPS Reporting
The role of a radio participating in GPS (Global Positioning System) reporting can be pre-
selected via R&S RNMS3000 or dynamically selected via MMI (Man-Machine Interface) /
REMOTE interfaces.
Provider
A GPS provider is a radio providing GPS positioning data to other GPS participants. It does
so by
manually or automatically pushing its current GPS position information onto the network,
responding to GPS control / configuration requests being received over the air from an-
other, dedicated radio GPS participant called GPS controller.
Controller
A GPS controller is a dedicated radio GPS participant being able to
request (pull) GPS positioning information from other participants and
control / configure the automatic GPS transmission of other participants.
The controller commands other GPS participants over the air by using the radio dedicated
GPS control commands. The transmission of these commands can be initiated manually via
the MMI or via the radio REMOTE interface by an external application.
There can be one or multiple GPS controllers in a waveform specific network. It is an orga-
nizational challenge to ensure that control requests of multiple controllers do not conflict.
Controller Acting as Provider
In order to ensure that the GPS positioning information of a controller radio remains “hidden”,
by default a controller does not respond to pull and control / configuration messages received
from another controller. Also, it does by default not take part in automatic GPS reporting (see
sect. 5.2.1.2 Types of GPS Transmission). If a controller shall exceptionally support the
above actions, the mode "Controller Reports Position (CRP)", needs to be enabled. The CRP
state (enabled or disabled) can be pre-selected via R&S RNMS3000 or dynamically enabled
/ disabled via the MMI / REMOTE interfaces. When CRP is enabled, a controller also auto-
matically transmits its own GPS positioning information when pulling or configuring other
GPS participants.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the R&S M3SR 4100 Series and is the answer not in the manual?

R&S M3SR 4100 Series Specifications

General IconGeneral
BrandR&S
ModelM3SR 4100 Series
CategoryRadio
LanguageEnglish

Related product manuals