M3SR Series 4100 Selecting the Voice Priority over IP Data Function
4.108 Operating Manual 6175.4760.02 – 01
4.4.5.17 Selecting the Voice Priority over IP Data Function
Softkey Selection / Editor Description
Listbox 1. Press 'VPoD' softkey.
2. Select desired value from listbox.
3. Press 'ENT' to confirm.
The value is now effective.
Possible values:
•OFF
•ANALOG VOICE
• SEG DIG VOICE
• LAST DITCH VOICE
The call-address for a voice-link is selected
by the “next call address”, which is config-
urable by the user. When an IP-data link is
established, the “next call address” is
changed to the current link partner. After
termination of the IP-data link the previous
“next call address” is restored, except if it
was changed by the user while the IP-data
link is active.
To Next Page
Loading...
Need help?
General
