R&S M3SR 4100 Series - Storing Current Settings

M3SR Series 4100 Storing Current Settings
3.204 Operating Manual 6175.4760.02 – 01
3.9.4.1 Storing Current Settings
Softkey Softkey Type Description
Editor 1. Press 'Channel Store' softkey.
2. Enter desired channel.
3. Press 'ENT' key to confirm.
If the entered channel number is within the
permitted entry range, the editor window will
be closed.
Possible values:
Channels 1 to 400, modifiable by using the
R&S RNMS3000 software tool.
With the R&S RNMS software tool you can
configure these channels as modifiable or
not modifiable by the user.
Channel store/recall is only available on Pre-
set Page 0. Other Fixed Frequency Preset
Pages consist only of one channel.
400 channels are always available on Preset
Page 0 independent of the number of further
Preset Pages assigned to Fixed Frequency
operation.
The 'Channel store' softkey is used to store
Fixed Frequency parameters set on the radio.
Settings can be recalled as described in
sect. 3.7.3.2 Recalling Settings.
The following parameters are stored in a chan-
nel:
• Modulation
• Bandwidth
• Data rate
• Noise blanker
• Power
• FSK run / stop function
• Frequency shift F3
• Frequency
• BFO frequency
• Delta frequency
•Polarity
• Preamplifier
• Frequency shift F1
• Squelch
• Data link mode (option see
sect. 4.6 Link SW)