M3SR Series 4100 Text Editor
5.96 Operating Manual 6175.4760.02 – 01
5.4.2.3 Text Editor
Figure 5.25 Menu 1341 Msg Service 1/2, Text Editor
To edit a message you can use the softkeys on the left-hand and right-hand side or the nu-
meric keypad of R&S GB 4000C.
The number in the first line of the softkey label refers to the corresponding number on the
numeric keypad.
To write a 'b' you can either press the softkey '2' twice, or you press the key '2' on the keypad
twice.
To write an uppercase letter use the 'Caps Lock' softkey to switch this function on. All letters
you enter will be written in uppercase letters until you switch 'Caps Lock' off.
The 'Delete' softkey deletes the letter preceding the curser if 'Mode' is set to 'Move'.
If a part of the text is selected, this selection will be deleted.
To move the cursor use the rotating knob on R&S GB 4000C.
To select one or more letters set 'Mode' to 'Select', and use the rotating knob to mark the
letters. The selected letters will be underlined in blue.
Depending on whether you entered the editor menu from the Drafts or Send folder, the top
right button shows 'SAVE' or 'SEND' to store the message or to send it immediately.
ICN-4D-G-231053-R-D0894-00002-A-01-1
To Next Page
Loading...
Need help?
General
