M3SR Series 4100 Rebroadcast / Relay Mode
5.66 Operating Manual 6175.4760.02 – 01
Relay IP Broadcast Forwarding
All radios in a relay scenario belong to the same subnet. Therefore, an IP broadcast of one
radio (e.g. an alert message or a GPS tracking report) would be consumed by the relay Rx
radio, but would not be propagated to all other radios. To provide also a forwarding of such
broadcast messages to the other radios, a "Relay IP Broadcast Forwarding" can be enabled.
The feature can be enabled/disabled by R&S RNMS3000 configuration, MMI or remote con-
trol (GB2PP).
This functionality is only intended for use in relay scenarios. Do not enable in case of
a rebroadcast scenario (not conform to RFC 791 and RFC 2644).
Local Voice Participation
A user located at a relay station can listen to the local waveform net by using an analog
equipment at the Rx radio and speak at the Tx radio's handset. This functionality can be en-
abled/disabled by R&S RNMS3000 configuration, MMI or remote control (GB2PP).
Disabling this functionality may be desired in order to prevent monitoring the voice traffic, e.g.
at an unguarded station.
To Next Page
Loading...