R&S M3SR 4100 Series User Manual

Operating Manual 6175.4760.02 – 01 5.31
M3SR Series 4100 Switching the Controller Reports Position as Controller Feature On or Off
5.2.2.11 Switching the Controller Reports Position as Controller Feature On or Off
By means of softkey 'CRP' the operator can enable / disable the controller feature CRP (Con-
troller Reports Position) and permit a controller also to act as provider (see also
sect. 5.2.1.1 Roles of Radios Supporting GPS Reporting).
The influence of the currently selected CRP status is summarized in Table 5.3.
Table 5.3 Influence of the Currently Selected CRP Status
The terms "at least once" and "never received" refer to the GPS satellite reception after the
preset page supporting GPS reporting has been selected.
Softkey Type Description
Activate Repetitively pressing this key toggles the fea-
ture on and off.
The new setting is immediately effective.
Expected Action CRP is off (disabled) CRP is on (enabled)
Controller responds to immediate
pull request being received from
another controller.
No, controller disregards immedi-
ate pull requests.
Yes, controller responds immedi-
ately (even if GPS time signal has
not been received yet).
Controller responds to standard
pull request being received from
another controller.
No, controller disregards standard
pull requests.
Yes, controller responds using
scheduled transmission (assuming
the GPS time signal has been re-
ceived at least once).
Controller responds to Auto Push
Config Request (APR) being re-
ceived from another controller.
No, controller disregards APR re-
quest.
Yes, controller starts to execute
auto push operation using sched-
uled transmission (assuming the
GPS time signal has been received
at least once).
Controller starts to execute RNMS
(Radio Network Management Sys-
tem) based auto push configura-
tion.
No, controller disregards RNMS
auto push configuration.
Yes, controller starts to execute
auto push operation using sched-
uled transmission (assuming the
GPS time signal has been received
at least once).
Controller transmits its own GPS
(Global Position System) position-
ing information when pulling or con-
figuring other GPS participants.
No, controller does not transmit its
own GPS position.
Yes, controller does transmit its
own GPS position (if available).

R&S M3SR 4100 Series Specifications

General

Brand	R&S
Model	M3SR 4100 Series
Category	Radio
Language	English