M3SR Series 4100 FastLink Mode (FLM)
5.48 Operating Manual 6175.4760.02 – 01
Table 5.8 shows the state transitions and the events causing the state transition:
Table 5.8 State Transitions (Events)
Table 5.9 State Transitions (Rebroadcast)
No. Old State New State Event
1 Idle Connecting Connection establishment pending.
2 Connecting ConnectedTx Connection established.
3 Connecting Idle Connection request failed, e.g. destination not reachable.
4 Connecting Busy Other station won competition for connection (other station
tries to set up a connection to a 2
nd
other station).
5 ConnectedTx Disconnecting Connection termination initiated by user.
6 Disconnecting Idle Connection termination finished.
7 ConnectedTx Idle Idle timeout.
8 Idle Busy • External connection established.
• External FastLink data transmission detected.
9 Busy Idle • External connection termination.
• Idle timeout.
10 Idle ConnectedRx Connection established.
11 ConnectedRx Idle • Connection termination (initiated by active Tx station).
• Idle timeout.
12 Connecting ConnectedRx Other station won competition for connection (other station
tries to set up a connection to this radio).
No. Old State New State Event
100 Connecting Rebro-Connecting Connection establishment over rebroadcast pend-
ing .
101 Rebro-Connecting Rebro-Busy A remote network in rebroadcast scenario is busy.
102 Rebro-Connecting ConnectedTx Connection over rebroadcast established.
103 Rebro-Connecting Idle Connection request failed, e.g. destination not
reachable.
104 Connecting Rebro-Busy Remote network in rebroadcast scenario is busy.
The Rebro-Busy state indicates that the connection
request failed due to a busy remote network (and not
due to a non-reachable station).
This transition is followed immediately by the next
transition (105).
105 Rebro-Busy Idle Remote network in rebroadcast scenario is busy.
To Next Page
Loading...