Operating Manual 6175.4760.02 – 01 7.11
M3SR Series 4100 Care, Cleaning
7.2 Care, Cleaning
7.2.1 Care
Such measures involve cleaning and touching up slight blemishes to the varnish of the sys-
tem. The materials indicated on the list of materials (see Table 7.1) are required:
Table 7.1 List of Materials
7.2.2 Cleaning
Wear protective goggles to protect your eyes if you are working with compressed air.
Ensure that the compressed air is free of condensed water by first blowing the com-
pressed air towards the ground.
Keep a minimum distance of 20 cm between compressed air and the system.
Do for cleaning not use solvents (thinners etc.), petroleum ether or alcohol.
Such substances will irreversibly damage the varnish coat.
1. First clean the surface of the system with compressed air.
2. Continue cleaning with a soft brush or a duster.
3. Clean heavily contaminated surfaces, especially grease stains, with a soft, lint-free cloth
moistened with detergent.
Item Description
1 Soft brush
2Duster
3 Cleaning compounds, e.g. household detergent
4 Varnish front panel: RAL 7947
Telegray chassis: KB90 gray (RAL 7001)
To Next Page
Loading...
Need help?
General
