M3SR Series 4100 Editing a User Hopset Subband
4.200 Operating Manual 6175.4760.02 – 01
Editing a User Hopset Subband
By means of the softkey 'Edit' the operator can modify a user hopset subband.
Softkey Type Description
Example for modifying a current hopset band
with the range of 3000 kHz up to 6000 kHz
Start from band menu of the desired user
hopset.
Select with the knob the hopset subband to be
edited.
1. Press softkey 'Edit' to open hopset fre-
quency editor.
2. Modify the lower hopset band frequency.
3. Press 'ENT' to confirm.
4. Modify the upper hopset band frequency.
5. Press 'ENT' to confirm.
6. To complete the insertion press the 'Save'
softkey.
The modification is now complete.
The frequency spacing is 5 kHz (via MMI).
If the operator tries to configure a hopset
subband with a total frequency spacing dif-
ferent from a multiple of 5 kHz, the radio
will adapt the higher frequency automati-
cally after saving the changes.
Press 'Edit' to change to frequency editor.
The frequency editor for Low Frequency will
open.
Enter new lower frequency of subband.
To Next Page
Loading...
Need help?
General
