Operating Manual 6175.4760.02 – 01 5.117
M3SR Series 4100 Accept an Incoming Call
5.5.2.3 Accept an Incoming Call
Softkey Type Description
Activate When an incoming call arrives, an acoustic
signal announces it and the message ‘incom-
ing’ is displayed in central area of the screen
(Call State)
The operator can accept the incoming call by
pressing the ‘Accept’ softkey.
An operator is able to accept an incoming
call only before the time defined by the Au-
tomatic Call Accept Delay parameter ex-
pires.
If the Automatic Call Accept Delay parameter
configured for the VoIP gateway radio via the
R&S RNMS3000 is enabled, after the time de-
fined by this parameter, the incoming call is
accepted automatically by the VoIP gateway
radio (see sect. 5.5 Voice over IP (VoIP):
Phone Service – Call Initiation)
To Next Page
Loading...