R&S M3SR 4100 Series - Changing the Frequency for SDV Communication; Changing the Power Level for SDV Communication; SEC VOICE Operational Menu

M3SR Series 4100 SEC VOICE Operational Menu
4.150 Operating Manual 6175.4760.02 – 01
4.7.4 SEC VOICE Operational Menu
Figure 4.34 Menu1611: Sec. Voice OP 1/1
4.7.4.1 Changing the Frequency for SDV Communication
Rx and Tx frequencies can be changed either by using the knob, if the Smart Frequency Ed-
itor (SFE) is enabled, or by means of the softkey 'FREQ'.
These procedures are explained in
sect. 3.5 Control Unit Maintenance and
sect. 3.7.2.15 Changing the Frequency.
4.7.4.2 Changing the Power Level for SDV Communication
By means of softkey 'Power' the operator can change the output power level.
This procedure is described insect. 3.7.2.21 Selecting the Power Level.
ICN-4D-J-231003-R-D0894-00005-A-01-1