Operating Manual 6175.4760.02 – 01 3.183
M3SR Series 4100 Radio Configuration with Pre-configured Parameters
3.8 Radio Configuration with Pre-configured Parameters
While downloading data from a fillgun it is not possible to load a mission directly from
a PC into the R&S M3SR Series 4100 radio using the PC software RDL (Remote Device
Loader), because they are configuring the same R&S M3SR Series 4100 database. If
RDL is needed, please wait until a running fillgun download has finished.
This documentation provides information about loading a radio with pre-configured parame-
ters. It is divided into several sections
• Introduction
• Possibilities to load the configuration to the radio
• Default FF settings if no configuration is loaded
3.8.1 Introduction
After delivery from factory (and after erasure, see sect. 3.2 Operating Concept) only one Pre-
set Page is available (see Figure 3.75 and also sect. 3.3 Control and Monitoring of Radio
and Control Unit). This is Preset Page 0 configured with communication mode FF (see
Figure 3.75) with a set of default FF parameters.
To Next Page
Loading...