Operating Manual 6175.4760.02 – 01 3.113
M3SR Series 4100 Control Unit MTC 2/4 (4002)
Be careful if you change the IP settings. For the configuration of a greater network,
detailed knowledge concerning IP networks is required. Such knowledge is not im-
parted by this documentation. Please ask your network administrator or refer to ap-
propriate technical literature, if necessary.
Open an editor to change the control unit IP address.
Use the knob or the numeric keypad to edit each of the four
numbers of the address separately.
To select the next number press the key
1.0.0.0 to 255.255.255.255
.
Press 'ENT' to confirm.
A message box appears: Please reboot the CU to make
this change take effect.
There are not all IP addresses allowed. See also the
note below.
Default: 192.168.52.4
Navigate to the menu CU MTC 3/4 (see sect. 3.5.3 Control
Unit MTC 3/4 (4003)).
Softkey Description Possible Values
To Next Page
Loading...