STMicroelectronics STM32F05 series User Manual

RM0091 Touch sensing controller (TSC)
Doc ID 018940 Rev 1 691/742
Bit 15 SSPSC: Spread spectrum prescaler
This bit is set and cleared by software. It selects the AHB clock divider used to generate the
spread spectrum clock (f
SSCLK
).
0: f
HCLK
1: f
HCLK
/2
Note: This bit must not be modified when an acquisition is on-going.
Bits 14:12 PGPSC[2:0]: pulse generator prescaler
These bits are set and cleared by software.They select the AHB clock divider used to
generate the pulse generator clock (f
PGCLK
).
000: f
HCLK
001: f
HCLK
/2
010: f
HCLK
/4
011: f
HCLK
/8
100: f
HCLK
/16
101: f
HCLK
/32
110: f
HCLK
/64
111: f
HCLK
/128
Note: These bits must not be modified when an acquisition is on-going.
Bits 11:8 Reserved, must be kept at reset value.
Bits 7:5 MCV[2:0]: Max count value
These bits are set and cleared by software. They define the maximum number of charge
transfer pulses that can be generated before a max count error is generated.
000: 255
001: 511
010: 1023
011: 2047
100: 4095
101: 8191
110: 16383
111: reserved
Note: These bits must not be modified when an acquisition is on-going.
Bit 4 IODEF: I/O Default mode
This bit is set and cleared by software. It defines the configuration of all the TSC I/Os when
there is no on-going acquisition. When there is an on-going acquisition, it defines the
configuration of all unused IOs (not defined as sampling capacitor I/O or as channel I/O).
0: I/Os are forced to output push-pull low
1: I/Os are in input floating
Note: This bit must not be modified when an acquisition is on-going.
Bit 3 SYNCPOL: Synchronization pin polarity
This bit is set and cleared by software to select the polarity of the synchronization input pin.
0: Falling edge only
1: Rising edge and high level
Bit 2 AM: Acquisition mode
This bit is set and cleared by software to select the acquisition mode.
0: Normal acquisition mode (acquisition starts as soon as START bit is set)
1: Synchronized acquisition mode (acquisition starts if START bit is set and when the
selected signal is detected on the SYNC input pin)
Note: This bit must not be modified when an acquisition is on-going.

STMicroelectronics STM32F05 series Specifications

General

Brand	STMicroelectronics
Model	STM32F05 series
Category	Microcontrollers
Language	English