e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
OUTLINE OF THE MACHINE
3 - 56
[E] Waste toner box replacement
[F] Call for service
Check the error code displayed on the control panel when “Call for service” appears, and deal with
the abnormality referring to the error code table.
P. 8-6"8.2 Error Code List"
• The registration sensor (S52) detects jamming of the leading edge of the paper:
The registration sensor (S52) is not turned ON within a fixed period of time after the leading edge
of the paper passed the transport roller.
Paper jam (E120, E200, E210, E300, E330 and E3C0)
• During paper feeding from the ADU:
The registration sensor (S52) is not turned ON within a fixed period of time after the ADU motor
(M7, 8) is turned ON.
Paper jam (E110)
• During paper transporting from the ADU:
The duplexing unit path sensor (S66, S67) do not detect the paper at the fixed timing.
Paper jam (E510 and E520)
• During paper feeding from the equipment or the PFP:
The registration sensor (S52) is not turned ON within a fixed period of time after the feed clutch is
turned ON.
Paper jam (E220, E310, E320, E340 to E360, E3D0 and E3E0: The error code differs depending
on the paper source.)
• The waste toner box is full of used toner
Waste toner box full detection sensor (S14) ON
“Dispose of used toner” is displayed
• The waste toner box full detection sensor (S14) is turned ON during printing
Printing is stopped after the paper being printed has exited
Solution: Replace the waste toner box with a new one and close the waste toner box cover.
To Next Page
Loading...
