Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Drum Motor-K; Drum Motor-YMC

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 118
4.6.30 Drum motor-K (M27)
4.6.31 Drum motor-YMC (M28)
(1) Take off the rear cover.
 P. 4-7"4.1.18 Rear cover"
(2) Disconnect 1 connector and remove 2
screws. Then take off the drum motor-K [1].
Notes:
Never loosen red screws fixing a rubber
damper.
Fig. 4-346
(1) Take off the rear cover.
 P. 4-7"4.1.18 Rear cover"
(2) Disconnect 1 connector and remove 2
screws. Then take off the drum motor-YMC
[1].
Notes:
Never loosen red screws fixing a rubber
damper.
Fig. 4-347
Notes:
When installing the motor, make sure that
the mark of the gear is within the area of the
cutout (within the area indicated by the
arrow) of the bracket (3 positions at the same
time).
Fig. 4-348
[
1
]
[
1
]
Mark