Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Transfer Belt Cam Motor; Transfer Belt Contact;Release Detection Sensor

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 148
4.7.8 Transfer belt cam motor (M14)
4.7.9 Transfer belt contact/release detection sensor (S46)
(1) Take off the transfer belt unit.
 P. 4-144"4.7.6 Transfer belt unit (TBU)"
(2) Disconnect 1 connector and remove 2
screws. Then take off the bracket [1].
Fig. 4-432
(3) Remove 2 screws and then take off the
transfer belt cam motor.
Notes:
Pay attention to the size (length) of the
screws. If incorrect ones are used, the motor
could be damaged.
Fig. 4-433
(1) Take off the transfer belt.
 P. 4-146"4.7.7 Transfer belt"
(2) Disconnect 1 connector [1] and release 3
latches. Then take off the transfer belt
contact/release detection sensor [2].
Fig. 4-434
[
1
]
Screw
Transfer belt cam motor
[
1
]
[
2
]