3
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
OUTLINE OF THE MACHINE
3 - 79
[D] Drawer feeding
[D-1] 2nd drawer
• The feed motor and transfer motor are turned ON, and the pickup roller, feed roller and transport
roller are rotated to start feeding paper.
• Passing of the leading edge of the paper turns ON the 2nd drawer feed sensor, then the 2nd
transport sensor is turned ON.
• Passing of the leading edge of the paper turns ON the registration sensor and the paper is aligned
by the registration roller.
• The transport motor is turned OFF and the transport roller is stopped.
• The registration motor and transport motor are turned ON and the paper is transported to the 2nd
transfer position.
[D-2] 1st drawer
• The feed motor and the transport motor are turned ON, and the pickup roller, feed roller and
transport roller are rotated to start feeding paper.
• Passing of the leading edge of the paper turns ON the 1st drawer feed sensor, then the 1st transport
sensor is turned ON.
• Passing of the leading edge of the paper turns ON the registration sensor and the paper is aligned
by the registration roller.
• The transport motor is turned OFF and the transport roller is stopped.
• The registration motor and transport motor are turned ON and the paper is transported to the 2nd
transfer position.
To Next Page
Loading...
