e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 206
4.10 Exit / Reverse / Duplex Section
4.10.1 Upper exit section cooling fan-1(F32) / Upper exit section cooling
fan-2 (F33)
4.10.2 Lower exit section cooling fan-1(F34) / Lower exit section cooling
fan-2 (F35)
(1) Take off the receiving tray.
P. 4-3"4.1.8 Receiving tray"
(2) Remove 2 screws and disconnect 2
connectors. Then take off the upper exit
section cooling fan unit.
Fig. 4-596
(3) Release the harness from the clamp.
(4) Take off the upper exit section cooling fan-1
and the upper exit section cooling fan-2 by
removing 2 screws from each.
Fig. 4-597
(1) Take off the receiving tray.
P. 4-3"4.1.8 Receiving tray"
(2) Take off the left top cover.
P. 4-4"4.1.10 Left top cover"
(3) Lift up the reverse path cover. Then take off
the lower exit section cooling fan-1 and the
lower exit section cooling fan-2 by removing
2 screws and disconnecting 1 connector of
each.
Fig. 4-598
Upper exit section cooling fan unit
Upper exit section
cooling fan-1
Upper exit section
cooling fan-2
Lower exit section cooling fan-1
Lower exit section cooling fan-2
To Next Page
Loading...
