Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Bypass Feed Roller; Bypass Transport Roller

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 49
4.5.7 Bypass feed roller
4.5.8 Bypass transport roller
(1) Take off the bypass upper unit.
 P. 4-45"4.5.2 Bypass feed unit"
(2) Remove the clip and take off the bypass feed
roller.
Notes:
Make sure the following items when
assembling the bypass feed roller.
1. Set the timing belt to the pulley securely.
2. Do not put the wrong position when
setting the timing belt.
3. Be sure to insert the clip into the groove
of shaft.
4. Check that there is no stain such as oil on
the surface of timing belt, the pulley and
the roller.
5. Install the bypass pickup roller and the
bypass feed roller in the correct direction.
Fig. 4-138
(1) Take off the bypass upper unit.
 P. 4-48"4.5.6 Bypass upper unit"
(2) Remove 1 E-ring and slide the bushing to the
inner side.
Fig. 4-139
(3) Move the shaft to the right side and remove
the left bushing. Then take off the bypass
transport roller.
Fig. 4-140
Bypass feed roller
Bushing
Bypass transfer roller