Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Bridge Unit Path Entrance Sensor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 229
4.10.25 Bridge unit path entrance sensor (S55)
(4) Take off transport path switching solenoid-2
by removing 2 screws.
Fig. 4-664
(1) Take off the reverse roller.
 P. 4-225"4.10.20 Reverse roller"
(2) Take off transport guide-2 by removing 5
screws.
Notes:
The type of the screw differs depending on
the installation position.
Fig. 4-665
(3) Remove 1 screw and then take off the
sensor bracket.
(4) Release the harness from 2 clamps and then
disconnect the connector.
Fig. 4-666
Front side
Transport path
switching solenoid-2
Shoulder screw
Shoulder screw
Sensor bracket