Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Tandem LCF Tray-Up Motor

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 79
4.5.49 Tandem LCF tray-up motor (M46)
(4) Release 3 latches and then take off the
transfer belt paper clinging detection sensor.
Fig. 4-230
(1) Pull out the tandem LCF.
(2) Take off the FIL board case and reactor.
 P. 9-21"9.1.18 FIL board"
(3) Take off the switching regulator.
 P. 9-18"9.1.15 Switching regulator (PS)"
(4) Take off the PFC board case.
 P. 9-8"9.1.9 PFC board case"
(5) Disconnect 1 connector and remove 3
screws. Then take off the tandem LCF tray-
up motor unit.
Fig. 4-231
(6) Release 2 latches and then take off the
coupling [1] and spring [2].
Fig. 4-232
Transfer belt paper clinging detection sensor
Tandem LCF tray-up motor unit
[
1
]
[
2
]