Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Transport Guide-1; Transport Guide-2

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 174
4.9.3 Transport guide-1
4.9.4 Transport guide-2
(1) Take off the fuser unit.
 P. 4-172"4.9.1 Fuser unit"
(2) Take off the pressure roller cover.
 P. 4-173"4.9.2 Pressure roller cover"
(3) Remove 2 screws and then take off the
transport guide-1 [1].
Notes:
When installing, fully tighten the 2 pressure
screws until they are no longer turned.
Fig. 4-499
Notes:
Place transport guide 1 as shown in the
figure so that its separation finger [1] does
not become damaged.
Fig. 4-500
(1) Take off transport guide-1.
 P. 4-172"4.9.1 Fuser unit"
(2) Remove 2 screws and take off transport
guide-2 [1].
Fig. 4-501
[
1
]
[
1
]
[
1
]
[
1
]