6
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6 - 27
[G] Right margin
1. While pressing [0] and [5] simultaneously, turn the power ON. (Adjustment Mode)
2. Open the RADF.
3. Press [FAX] [START] to make a copy at the mode of A3/LD, 100%, Full color, Text/Photo
and 2nd drawer.
4. Measure the blank area F at the right side of the copied image.
5. Check if the blank area F is within the range.
6. If not, use the following procedure to change values and repeat the steps 3. to 5. above.
<Procedure>
(Adjustment Mode) (Key in the code [4052]) [START]
(Key in a value (acceptable values: 0 to 255))
[OK] or [INTERRUPT] (Stored in memory).
(“100% A” is displayed.)
* The larger the adjustment value is, the wider the blank area at the right side becomes
(approx. 0.04 mm/step).
Fig.6-19
Function Black Color
Copy 2±2.0 mm 2±2.0 mm
To Next Page
Loading...
