6
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6 - 63
6.3.13 Screen switchover
<Adjustment Mode (05)>
When “0” is set for “05-8176” or “05-8179” (EFI printer board), the level of the screen ruling in the Black
mode can be individually switched by the following codes:
Notes:
When the screen is switched, perform P. 6-49"6.3.1 Automatic gamma adjustment".
<Procedure>
The procedure is the same as that of P. 6-58"6.3.4 Adjustment of faint text".
Code Remarks
8176 The level of the screen ruling when “Smooth” is selected for the “Halftone” in
the “Detailed setting” in the Image quality tab of the printer driver can be
switched.
0: High screen ruling value (smoother image)
1: Low screen ruling value (rougher image)
8179
(EFI Printer Board)
Code
Item to be
adjusted
Remarks
8187
Graphics
The level of the screen ruling in the Black mode is switched.
0: High screen ruling value (fine)
1: Low screen ruling value (rough)
* It is enabled only when “0” is set for “05-8176”. When “1” is set
for “05-8176”, the setting by this code is disabled and low screen
ruling value is applied.
8188
Image
8190
(EFI Printer board)
Graphics
The level of the screen ruling in the Black mode is switched.
0: High screen ruling value (fine)
1: Low screen ruling value (rough)
* It is enabled only when “0” is set for “05-8179”. When “1” is set
for “05-8179”, the setting by this code is disabled and low screen
ruling value is applied.
8191
(EFI Printer board)
Image
To Next Page
Loading...
Need help?
General
