Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Precautions and Procedures When Replacing SRAM Board

9
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
9 - 35
9.2.6 Precautions and Procedures when replacing SRAM board (for
SYS board)
Notes:
• Do not replace the HDD and the SRAM board (for the SYS board) together.
• Be careful not to damage the board when replacing the SRAM board.
• When the SRAM board is replaced, do not perform HDD partition creation (Format HDD)
before the normal start-up.
A procedure for replacing the SRAM board is shown below.
When disposing of the SRAM board, perform the items in  P. 9-50"9.3.4 Precautions when disposing
of the SRAM board (for SYS board)".
Fig. 9-67
Notes:
“[G] Backup ADI key” is required only for the equipment in which the ADI-HDD has been
installed. Other procedures are the same as those for installing the SATA-HDD.
START
[A]
[E]
[B]
[C]
[D]
[F]
[H]
[G]
END
[I]
[J]
[L]
[K]
[M]
[O]
[N]
[P]
ADI-HDD
SATA-HDD