Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Image Dislocation in Feeding Direction

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 330
8.5.22 Image dislocation in feeding direction
Fig.8-31
Cause/Section Step Check item Measures
Adjustment
error of
scanner or
printer section
1 Is same dislocation on every copy? Adjust the scanner/printer using the
Adjustment Mode.
Registration
roller
2 Is the registration roller dirty, or is the
spring removed?
Clean the roller with alcohol.
Reinstall the spring.
3 Is the registration motor
malfunctioning?
Adjust or replace the gears, etc. if
they are not engaged properly.
4 Is the registration motor operating
normally? (Is the timing of operation
delaying?)
Replace the registration motor.
Paper feed
clutch,
Transport
clutch
5 Are the paper feed clutch and
transport clutch malfunctioning?
Check the circuit or the clutch and
replace them if necessary.
Aligning
amount
6 Is the aligning amount proper? Decrease the aligning amount.
Each roller 7 Are the roller and shaft not fixed
securely?
Check the E-ring, pin and clip.
8 Is the roller surface dirty? Clean the roller surface with alcohol
or replace it.
Registration
guide
9 Is the registration guide improperly
installed?
Reinstall the guide.
Feeding direction