Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Adjustment Procedure of the Bypass Feed Unit

6
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6 - 85
[ 2 ] Adjustment procedure of the bypass feed unit
(4) Tighten the screw that was temporarily
screwed.
Notes:
In this step check the film attached before
the separation roller because the roller life
may become shorter if this film is scraped
and worn.
Reference value of distance C (from the
edge of the plate to that of the film): 7.0±0.2
mm
* If the distance C is 6.5 mm or shorter, the
film must be replaced.
Fig.6-34
(1) Take off the bypass feed tray.
 P. 4-45"4.5.1 Bypass feed tray"
(2) Remove 1 screw and take off the bracket [1].
Fig.6-35
(3) Remove 4 screws and take off the SFB lower
unit [1].
Fig.6-36
C
[1]
[1]