Toshiba e-STUDIO 6550Ce-STUDIO 5560C - External Counters; Signal; Pin Layout

13
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
EXTERNAL COUNTERS
13 - 1
13. EXTERNAL COUNTERS
13.1 Outline
This specification describes the interface between external counters, such as Coin Controller and Key
Counter.
13.2 Signal
Notes:
Regarding the output signals of MP6H1 or 2SC5712 (CTRON), use 24V supplied from the
equipment side as power.
13.2.1 Pin Layout
1. Connector on the LGC board: CN318 (JST-made B16B-CZWHK-B-1(LF)(SN)) (Coin Controller)
Pin
No.
I/O Signal name Function Voltage level Remarks
GQ-
1200
GQ-
1210
A1 Power +24V 24V line DC24V+10%, -5% When cover
opened:
OFF
In use In use
A2 Out CTRON Total Counter On
Signal
Open Collector
(MP6H1/2SC5712)
L: ON In use In use
A3 In CTRCNT Copy permission
Signal 1
L=0V, H=DC5V L: Allowed In use In use
A4 Out MCRUN Ready to Copy
Signal
Open Collector
(SN7407/UMH10NTN)
L:
Operating
In use In use
A5 Out EXTCTR Exit Sensor On
Signal
Open Collector
(SN7407/UMH10NTN)
L: ON In use -
A6 GND PG Power ground 0V In use -
A7 Out BKCTR Black mode
Counter Signal
Open Collector
(SN7407/UMH10NTN)
L: ON - In use
A8 Out MNCTR Mono color mode
Counter Signal
Open Collector
(SN7407/UMH10NTN)
L: ON - In use
B1 Out FLCTR Full color mode
Counter On Signal
Open Collector
(SN7407/UMH10NTN)
L: ON - In use
B2 GND SG Signal Ground 0V - In use
B3 Out SIZE3 Paper size Signal Open Collector
(SN7407/UMH10NTN)
L: ON - In use
B4 Out SIZE2 Paper size Signal Open Collector
(SN7407/UMH10NTN)
L: ON - In use
B5 Out SIZE1 Paper size Signal Open Collector
(SN7407/UMH10NTN)
L: ON - In use
B6 Out SIZE0 Paper size Signal Open Collector
(SN7407/DTC123J)
L: ON - In use
B7 Power +5V (Sleep) 5V line DC5V+5%, -4% At the sleep
mode:OFF
In use In use
B8 In NC. - - - -