Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Input Check (Test Mode 03); Example of Display During Input Check

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 8
5.3 Input check (Test mode 03)
<Operation procedure>
Notes:
• Initialization is performed before the equipment enters the test mode.
• The PRINT DATA lamp blinks when the input check is running.
Fig.5-5 Example of display during input check
Refer to Chapter 15 in this manual for the items to be checked and the condition of the equipment when
the buttons [A] to [H] are highlighted.
The status of each input signal can be checked by pressing the [FAX] button, [COPY] button,
[SCAN] button and the digital keys in the test mode (03).
[0][3]
[POWER]
[START]
[FAX]
[COPY]
or
[SCAN]
[Digital keys]
[CLEAR]
(LCD ON)
[POWER] OFF/ON
(Exit)
[CLEAR]