Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Reverse Roller; Bridge Unit Exit Roller-1

4
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
4 - 225
4.10.20 Reverse roller
4.10.21 Bridge unit exit roller-1
(1) Take off the bridge unit.
 P. 4-213"4.10.11 Bridge unit"
(2) Take off the bridge unit front cover.
 P. 4-214"4.10.12 Bridge unit front cover"
(3) Take off the bridge unit upper cover.
 P. 4-219"4.10.16 Bridge unit upper cover"
(4) Take off each bracket of the bridge unit
transport entrance motor and the reverse
motor.
 P. 4-216"4.10.14 Bridge unit transport
entrance motor (M4) / Reverse motor (M3)"
(5) Remove 1 E-ring and the pulley.
(6) Remove 1 E-ring and move the bearing to
the inside.
Fig. 4-654
(7) Take off the reverse roller and the bearing
[1].
(8) Remove 1 E-ring and then remove the knob
[2] and pin [3] from the reverse roller.
Fig. 4-655
(1) Take off the bridge unit.
 P. 4-213"4.10.11 Bridge unit"
(2) Take off the bridge unit front cover.
 P. 4-214"4.10.12 Bridge unit front cover"
(3) Take off the bridge unit upper cover.
 P. 4-219"4.10.16 Bridge unit upper cover"
(4) Take off the motor bracket of the bridge unit
transport exit motor.
 P. 4-217"4.10.15 Bridge unit transport exit
motor (M5)"
(5) Remove 1 E-ring and then remove the gear
and the bearing.
Fig. 4-656
Bearing
[
1
]
[
1
]
[
2
]
[
3
]
Bearing