e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 224
(6) Remove 2 E-rings and the bushing to
remove the flap.
Fig. 4-650
(7) Remove the E-ring from the front side and
then take off the pulley and the belt.
Fig. 4-651
(8) Take off bridge unit transport guide-3 by
removing 5 screws.
Notes:
The type of the screw differs depending on
the installation position.
Fig. 4-652
(9) Remove 1 gear, 2 E-rings and 2 bearings.
Then take off bridge unit transport roller-3.
Fig. 4-653
Shoulder screw
Shoulder screw
To Next Page
Loading...
