Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Image Tilting on Leading Edge

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
8 - 348
8.5.34 Image tilting on leading edge
When a printed image at the leading edge of paper is tilted as shown below, correct this by adjusting
the bracket of TBU.
Fig.8-49
<Procedure>
(1) Confirm the condition of the image tilting with a grid pattern.
(2) Take off the transfer belt unit.
(3) Remove 2 screws and take off the bracket of the transfer belt unit.
(4) To improve the degree of image tilting by 0.5 mm or less: Align the bracket to the upper
alignment position and secure it with 2 screws.
To improve the degree of image tilting by 0.5 mm or more: Align the bracket to the lower
alignment position and secure it with 2 screws.
Remarks:
Image tilting on the leading edge can be adjusted in the range of 1 mm or less by adjusting the
bracket of the TBU. (Note that the improvement volume may decrease depending on the
equipment.)
Fig.8-50
Feeding direction
A Front
Tilted volume: A-B
B Rear
Upper
Lower
Bracket