e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 190
4.9.12 Fuser belt edge thermistor (THM6)
(8) Take off the fuser belt thermostat [1] by
removing 2 screws each.
Notes:
• Do not touch the temperature detection
section of the fuser belt thermostat [1].
• When replacing or taking off the fuser belt
thermostat [1], check the gap between
the fuser belt and its thermostat [1]. P.
6-96"6.11.1 Gap adjustment for fuser belt
thermostats"
• When assembling, fix the fuser belt
thermostat cable securely with a clamp
[1] so that it does not contact with the
fuser belt.
Fig. 4-549
Fig. 4-550
(1) Take off the transport guide-1.
P. 4-174"4.9.3 Transport guide-1"
(2) Take off the transport guide-2.
P. 4-174"4.9.4 Transport guide-2"
(3) Take off the rear plate.
P. 4-176"4.9.7 Separation plate"
(4) Remove 1 screw and take off the bracket of
the fuser belt edge thermistor.
Fig. 4-551
To Next Page
Loading...
