e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 42
6.2.12 Maximum toner density adjustment to paper type
The maximum toner amount adhering to the paper can be controlled.
It is used when offsetting occurs.
<Adjustment Mode (05)>
Notes:
Even if a large value is set, the image does not drastically appear dark (the amount of toner
adhering is not increased).
<Procedure>
The procedure is the same as that of P. 6-33"6.2.2 Density adjustment".
6.2.13 Maximum text density adjustment
The maximum text density in each color in the full color mode (Text/Photo, Text, Map mode) can be
adjusted.
<Adjustment Mode (05)>
Make a test copy and compare the image obtained with the current settings; if necessary, make
adjustments according to the following procedure.
Notes:
Be sure that this adjustment is made after performing P. 6-31"6.2.1 Automatic gamma
adjustment".
<Procedure>
The procedure is the same as that of P. 6-33"6.2.2 Density adjustment".
Code Paper type Remarks
7913-0
Plain paper 1 The smaller the value is, the toner amount adhered
decreases of the high density area (ex. prevention of
fusing offsetting, etc.).
Acceptable values: 0 to 255
(Default: 128)
7913-1
Plain paper 2
7913-2
Recycled paper
7913-3
Thick paper 1
7913-4
Thick paper 2
7913-5
Thick paper 3
7913-6
Thick paper 4
7913-7
Special paper 1
7913-8
Special paper 2
7913-9
OHP film
Color Code Item to be adjusted Remarks
Yellow 7889 Maximum text density The larger the value is, the darker the maximum
text density of each color to be adjusted becomes.
Acceptable values: 0 to 10 (Default: 5)
Magenta 7890
Cyan 7891
Black 7892
To Next Page
Loading...
