To Next Page

To Previous Page

SELF-DIAGNOSTIC MODE

5 - 51

[ 4 ] Relation between pixel count and toner consumption

The user’s printing out the image with large coverage or high density may cause the large value of pixel

count. And the setting that toner consumption becomes high in the original mode or density setting may

cause it as well.

In this case, the replacement cycle of toner cartridge is faster than the standard number of output

pages. Therefore, this trend needs to be grasped for the service.

The relation between pixel count and number of output pages per cartridge is as follows:

Fig.5-2 Pixel count and number of output pages per cartridge

[ 5 ] Pixel counter confirmation

• Display on LCD screen

Whether or not to display the pixel counter on the LCD screen is selected (0: Displayed, 1: Not

displayed) in the setting mode (08-6504), and whether or not to display it at the service technician

reference or toner cartridge reference is selected (0: Service technician reference, 1: Toner cartridge

reference) in the setting mode (08-6505).

The following screen is displayed when the buttons, [COUNTER] and [PIXEL COUNTER] are

pressed in this order after “Displayed” is selected with the code above and the power is, as usual,

turned ON. (The displayed buttons are depending on the setting of 08-6505.)

6% 12%

60%

Y/2

X/2

Y/10

X/10

Standard number of output pages (K)

Standard number of output pages (Y, M, C)

Number of output pages per cartridge (Page)

Pixel count (%)

Toshiba e-STUDIO 6550C e-STUDIO 5560C User Manual

Questions and Answers: