Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Maximum Density Adjustment for each Paper Type; ADF Noise Reduction

6
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
SETTING ADJUSTMENT
6 - 47
6.2.20 Maximum density adjustment for each paper type
The maximum density for each paper type can be adjusted collectively.
<Adjustment Mode (05)>
Notes:
Be aware that if too small a value is set, a faint image occurs.
<Procedure>
The procedure is the same as that of  P. 6-33"6.2.2 Density adjustment".
6.2.21 ADF noise reduction (Copying Function)
The noise reduction level for streaks can be adjusted with the following codes when a copy job whose
color mode is [BLACK] is performed using the ADF while its scan noise reduction function is set to
enable (*).
* When [LOW], [MIDDLE] or [HIGH] is selected in the [ADMIN] tab of the [USER FUNCTIONS] menu,
or when "0", "1" or "2" is selected in 08-7617.
<Adjustment Mode (05)>
When [FULL COLOR] or [AUTO COLOR] is selected for the color mode, the ADF noise reduction
function for streaks can be set to enable or disable with the following codes.
Notes:
• Remember the image specifications and life span of the replacing parts may not meet the
standard when the setting value is changed from the default value.
• If too small a value is set, the text may not be printed clearly.
Code Paper type Remarks
7902
Plain paper 1 The smaller the value is, the lower the density of the
whole image becomes.
Acceptable values: 0 to 255
(Default: Plain paper: 255, Thick paper 1: 255, Thick
paper 2: 255, Thick paper 3: 255, OHP film: 240,
special paper 1: 255, special paper 2: 255, Recycled
paper: 255, Thick paper 4: 255)
7903
Plain paper 2
7904
Recycled paper
7905
Thick paper 1
7906
Thick paper 2
7907
Thick paper 3
7908
Thick paper 4
7909
Special paper 1
7910
Special paper 2
7911
OHP film
Color mode
Original mode
Item to be
adjusted
Remarks
Text/
Photo
Text
Custom
mode
Black 7151 7152 7150 ADF scan
noise
reduction
When the value decreases, the effect of reducing
streaks becomes larger. When the value increases,
the effect of reducing streaks becomes smaller.
When “0” is set, this function is disabled.
Acceptable values: 0 to 200
(Default: 100)
Color mode
Original mode
Item to be
adjusted
Remarks
Text/
Photo
Text
Custom
mode
Color 7694 - 7693 ADF scan
noise
reduction
Enable/Disable setting
0: Disabled 1: Enabled
(Default: 1)
05-7693 is available only when “1” (TEXT/PHOTO
base) is set for 08-7614.