e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 74
6.4.7 Fine adjustment of black density
The density of black side on scanned image is adjusted at color-scanning.
<Adjustment Mode (05)>
Notes:
Be careful for the value not to be too large since the gradation is reproduced worse in darker
side.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the codes and press the [START] button.
(3) Key in the adjustment values. Acceptable values: 0 to 4. (To correct the value once keyed in,
press the [CLEAR] button.)
(4) Press the [OK] or [INTERRUPT] button to store the value in memory. The equipment goes
back to the ready state.
(5) Let the equipment restart and perform the scanning job.
(6) If the desired image has not been attained, repeat step (1) to (5).
Code Original mode Remarks
8315 Text The larger the value is, the black side of the image becomes darker.
Acceptable values: 0 to 4 (Default: 0)
8316 Printed Image
8317 Photo
8371 Custom mode
To Next Page
Loading...
Need help?
General
