Toshiba e-STUDIO 6550Ce-STUDIO 5560C

To Next Page

To Previous Page

FIRMWARE UPDATING

11 - 37

11.4.2 RADF firmware

Important:

• Be sure to shut down the equipment before installing and removing the download jig.

• Do not shut down the equipment during the update. The data could be damaged and not be

able to be operated properly.

[A] Update Procedure

(1) Install the ROM to the download jig (K-PWA-DLM-320).

Make sure the direction is correct.

(2) Press the [ON/OFF] button on the control panel to shut down the equipment.

(3) Take off the upper exhaust fan cover.

 P. 4-7"4.1.19 Upper exhaust fan cover"

(4) Take off the RADF rear cover.

Fig.11-29

(5) Connect the download jig with the jig connector on the RADF control PC board.

Fig.11-30

(6) Press the [ON/OFF] button while simultaneously holding down the [0] and [8] buttons.

Updating starts automatically and the LED on the download jig lights.

(7) After the update is completed properly, the LED on the download jig blinks (at an interval of

approx. 1 sec.).

Toshiba e-STUDIO 6550Ce-STUDIO 5560C - RADF Firmware