e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
7 - 36
* K8: Grounding plate
Apply 1 rice-sized grain of Floil (GE-334C) at the point that contacts with the shaft of the 2nd
transfer roller.
Fig. 7-39
* K9: Paper dust cleaning brush (registration roller)
Take off the paper dust removing brush (registration roller) from the 2nd transfer unit, and then
remove the paper dust on the brush with a vacuum cleaner.
* K12: TRU waste toner auger drive gear
After the TRU waste toner box was replaced, apply 1 rice-sized grain of white grease (Molykote
EM30-L) over the teeth of the TRU waste toner auger drive gear.
Fig. 7-40
To Next Page
Loading...
