Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Bridge Unit Transport Roller-2

To Next Page

To Previous Page

DISASSEMBLY and REPLACEMENT

4 - 222

4.10.18 Bridge unit transport roller-2

(1) Take off the reverse roller.

 P. 4-225"4.10.20 Reverse roller"

(2) Take off transport path switching solenoid-1.

 P. 4-227"4.10.23 Transport path switching

solenoid-1 (SOL1)"

(3) Take off transport guide-2 by removing 5

screws.

Notes:

The type of the screw differs depending on

the installation position.

Fig. 4-644

Notes:

The leaf springs with the idling rollers are

usually not needed to be disassembled,

however, if they are removed and installed,

fix the screws while pushing the rollers in the

direction of the arrow in the figure to prevent

the exit paper side deviation.

After the rollers are installed, check that the

rollers are parallel to the installation holes.

Fig. 4-645

(4) Remove 1 E-ring, the gear and the belt.

Fig. 4-646

Shoulder screw

Related product manuals