e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
SETTING ADJUSTMENT
6 - 62
6.3.12 Toner limit threshold adjustment
<Adjustment Mode (05)>
<600dpi>
<1200dpi>
Smooth
(PS/PCL/XPS)
Detail
(PS/PCL/XPS)
Paper type Remarks
8071-0
8070-0 Plain paper 1 When you set a larger value, the
density becomes high in some parts
of the high density area since the
maximum amount of toner adhering
increases.
When you set a smaller value, the
reproduction of the gradation tends to be
reduced since the maximum amount of
toner adhering decreases and the
maximum density becomes low.
Be aware that if too large a value is
set, offsetting occurs.
Acceptable values: 0 to 255
(Default: 128)
8071-1
8070-1 Plain paper 2
8071-2
8070-2 Recycled paper
8071-3
8070-3 Thick paper 1
8071-4
8070-4 Thick paper 2
8071-5
8070-5 Thick paper 3
8071-6
8070-6 Thick paper 4
8071-7
8070-7 Special paper 1
8071-8
8070-8 Special paper 2
8071-9
8070-9 OHP film
Smooth
(PS)
Detail
(PS)
Paper type Remarks
8090-0
8089-0 Plain paper 1 When you set a larger value, the
density becomes high in some parts
of the high density area since the
maximum amount of toner adhering
increases.
When you set a smaller value, the
reproduction of the gradation tends to be
reduced since the maximum amount of
toner adhering decreases and the
maximum density becomes low.
Be aware that if too large a value is
set, offsetting occurs.
Acceptable values: 0 to 255
(Default: 128)
8090-1
8089-1 Plain paper 2
8090-2
8089-2 Recycled paper
8090-3
8089-3 Thick paper 1
8090-4
8089-4 Thick paper 2
8090-5
8089-5 Thick paper 3
8090-6
8089-6 Thick paper 4
8090-7
8089-7 Special paper 1
8090-8
8089-8 Special paper 2
8090-9
8089-9 OHP film
To Next Page
Loading...
Need help?
General
