Toshiba e-STUDIO 6550Ce-STUDIO 5560C - 2 Nd Transfer Cam Motor; 2 Nd Transfer Cam Drive Unit

e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C © 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY and REPLACEMENT
4 - 164
4.7.26 2nd transfer cam motor (M48)
4.7.27 2nd transfer cam drive unit
(4) Release 3 latches. Then take off the 2nd
transfer roller contact/release detection
sensor.
Fig. 4-480
(1) Open the SYS board case.
 P. 9-2"9.1.3 SYS board case"
(2) Remove 1 connector [1] and 2 screws, and
take off 2nd transfer cam motor [2].
Notes:
Do not remove the 2 red screws fixing the
dumper
Fig. 4-481
(1) Open the SYS board case.
 P. 9-2"9.1.3 SYS board case"
(2) Remove 1 connector [1] and 2 screws, and
take off 2nd transfer cam drive unit [2].
Fig. 4-482
2nd transfer roller contact/release detection sensor
[
1
]
[
2
]
[
1
]
[
2
]