Toshiba e-STUDIO 6550Ce-STUDIO 5560C - Page 1047

8
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
8 - 291
Fig.8-4
Adjustment
In case the edges are towards the front side from (B):
Turn the stopper on the right front side clockwise to lift the equipment. The exit position will be moved
towards the rear side by approx. 0.6 to 1.0 mm for each turn.
Fig.8-5
In case the edges are towards the rear side from (B):
Turn the stopper on the left front side clockwise to lift the equipment. The exit position will be moved
towards the front side by approx. 0.6 to 1.0 mm for each turn.
Fig.8-6
Notes: Notes for installing the finisher
After the above adjustment, install the finisher according to the Unpacking Instructions.
When installing MJ-1103/1104, be sure to make the height adjustment in *29 to *30 in the
Unpacking Instructions.
(
A
)(
A
)
(
B
)(
B
)
LT A4
(
A
)
: Recommended range
(
B
)
: Allowable range
Scale for checking the paper exit position