9
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
REPLACEMENT OF PC BOARDS/HDD
9 - 49
(5) Install the one-time dongle in the equipment (the one which you used for uploading the selected
license), and then press the [OK] button.
(6) The Remove screen is displayed. Then press the [YES] button.
If this screen is not displayed, check that the one-time dongle is installed in the equipment
properly.
(7) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button.
If the screen for notifying a failure of the performance is displayed, quit this operation by pressing
the [CLOSE] button. Then check that the one-time dongle, which you used for uploading the
selected license, is installed in the equipment.
(8) Check that the returned license is not displayed on the screen.
Remarks:
If there are any other licenses to be returned, repeat from step (4).
If there are no other licenses to be returned, press the [CLOSE] button, and then turn the power
OFF.
(9) Replace the equipment.
(10) Turn the power ON while pressing [0] and [8] simultaneously.
(11) Enter the password, and then press the [OK] button.
(If the password is not set for Service, press the [ENTER] button without entering anything.)
(12) Key in [3840], and then press the [START] button.
(13) Press the [INSTALL] button.
(14) Install the one-time dongle in the equipment (the one which you used for returning the selected
license before replacing the equipment). Then press the [OK] button.
(15) Select the license to be installed, and then press the [INSTALL] button.
(16) The screen for notifying that the installation will be started is displayed. Then press the [YES]
button.
(17) After 10 to 40 seconds have passed, the screen for notifying the success of the performance is
displayed. Then press the [OK] button. If the screen for notifying a failure of the performance is
displayed, quit this operation by pressing the [NO] button. Then check that the one-time dongle is
installed properly in the equipment.
(18) Check that the installed license is displayed on the license list.
Remarks:
If there are any other licenses to be installed, repeat from step (13). If there are no other licenses
to be installed, press the [CLOSE] button, and then turn the power OFF.
To Next Page
Loading...
