11
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
FIRMWARE UPDATING
11 - 5
Notes:
• Written firmware varies depending on the kinds of the boards provided as service parts. For
updating, only the minimum firmware is installed on the system control PC board, logic PC
board, PFC PC board, scanning section control PC board, and FAX board. The latest version
of the firmware at the time of delivery is written on the RADF control PC board and finisher
control PC board. When any of above boards is replaced with a new one in the field, check
the other firmware version used and then update with a corresponding suitable version.
• The firmware (master data) is not installed on the hard disk provided as a service part. When
the hard disk is replaced with a new one, check the other firmware version used and then
write a corresponding suitable version.
• “Can't fetch Ver.” is displayed in the Installed Version field when the version of the installed
ROM cannot be acquired properly. If a normal power on is not performed after the firmware is
updated and the [ON/OFF] button is pressed while simultaneously holding down the [4] and
[9] buttons, “Can't fetch Ver.” may be displayed on the control panel for some ROMS. A
normal power on must be performed.
To Next Page
Loading...
